Vacuum packaging machine Shopping guide and maintenance - vacuum packing machine, packaging machine

A vacuum packaging machine Shopping guide
Vacuum pumps vacuum packing machine is the most important parts of his will have a direct impact on the quality of vacuum packaging machine is good or bad, so buy a vacuum packaging machine vacuum pump should pay attention to the quality, in general a good vacuum packaging machine may include the following:

1. Vacuum packaging machine exterior materials used: There is now divided into paint and stainless steel, stainless steel models are also different, and now with the best vacuum machine is 304 steel.

2. Vacuum packaging machine electrical differences, a good electrical components are not easily broken, poor electrical components is not the same.

3. Vacuum packaging machine design in all parts of the rationality of the link, installed fine on a good level of vacuum machines are to some extent.

4. Vacuum packaging machine vacuum pumps, there is some good and bad effects of the different use of the environment, different packaging, vacuum pump is good or bad will be apparent, mainly in the life of the vacuum pump and the pumping speed differences . vacuum pump maintenance is the key link, do not maintain a good vacuum is very easy to bad.

Second, the maintenance of vacuum packaging machine
1, vacuum packaging machine should be in the temperature of -10 ? 50 , relative humidity less than 85%, ambient air, corrosive gas, no dust, no explosive hazardous environments. The same as the baler and shrink machine, the vacuum packaging machine for the three-phase 380V power supply.

2, the vacuum packaging machine vacuum pump to ensure the normal work of vacuum pump motor does not allow reverse. Should always check the oil level, the normal oil level for the oil window 1/2-3/4 office (not more than), when there is water or oil pumps in the color black, the time should be replaced with new oil (usually one or two consecutive months to replace one with a # 30 # gasoline or petrol vacuum, oil can).

3, should always take apart and wash the filter impurities (usually 1-2 months, washed once, such as packaging debris like objects should shorten the cleaning time).

4, 2-3 months of continuous work should open the back cover is 30 to sliding parts and pieces lubricating touch switch on the heating of the connecting rod on the activities of Department should, as the use of lubrication.

5, on decompression, filtering, oil mist triple piece 24 to carry out regular checks to ensure that oil mist, oil cup of oil (sewing machine oil), filter cup water.

6, heating section, silicone strips to keep clean, not sticky a foreign body, so as not to affect the sealing quality.

7, heating rods, the heating film adhesive paste layer under the insulation from the role of timely and should be replaced when damaged, to avoid short circuit.

8, users bring their own work and inflated gas source gas source, vacuum packaging machine has been set for the working pressure 0.3MPa, more appropriate, no special circumstances do not regulate too much.

9, vacuum packaging machine in the removal process does not allow inclined position and impact, but not down to the ground handling.

10, vacuum packaging machine is installed must have a reliable grounding device.
11, are strictly forbidden to hand put into a heated rod, to prevent injury, turn off the power immediately in emergency situations.

12, working after the first powered ventilation, power shutdown after the first expire.

about author:
We are high quality suppliers, our products such as Electronic Pedometer Manufacturer , Alcohol Tester Manufacturer for oversee buyer. To know more, please visits Ear Thermometer.